Tuesday 4 June 2013
Final Prototype
MY STOOL!
Made out of 2mm Aluminium, powder coated in white and finished with 8mm nuts and bolts. I also created spacers with 10cm wooden feet and bearing spacers from a skateboard.
PHOTOS OF PROGRESS!!!
PHOTOS OF PROGRESS!!!
CURRENTLY WHERE I AM AT WITH MY MODEL!!!
PRACTISED BENDING WITH A CARD MODEL!!
GOT MY ALUMINIUM LASER CUT!
Thursday 30 May 2013
PHOTOS OF PROGRESS!!!
CURRENTLY WHERE I AM AT WITH MY MODEL!!!
PRACTISED BENDING WITH A CARD MODEL!!
GOT MY ALUMINIUM LASER CUT!
PRACTISED BENDING WITH A CARD MODEL!!
GOT MY ALUMINIUM LASER CUT!
Tuesday 14 May 2013
1:2 CARD MODEL
The thing i like about this design is i can have the aluminium (2-3mm) laser cut and then experiment with what i will use to hold the legs together (either use spacing or not) and also what screws will look good.
I will also need to look at what i will put at the bottom of the legs.
It will be one part cut three times to make this stool as each side is exactly the same.
I will also need to look at what i will put at the bottom of the legs.
It will be one part cut three times to make this stool as each side is exactly the same.
Paper 1:5 Model
I tested the folds and design with paper first to make sure the flat pack plan would work as i had hoped.....
Monday 13 May 2013
Subscribe to:
Posts (Atom)