I will also need to look at what i will put at the bottom of the legs.
It will be one part cut three times to make this stool as each side is exactly the same.
Tuesday 14 May 2013
1:2 CARD MODEL
The thing i like about this design is i can have the aluminium (2-3mm) laser cut and then experiment with what i will use to hold the legs together (either use spacing or not) and also what screws will look good.
I will also need to look at what i will put at the bottom of the legs.
It will be one part cut three times to make this stool as each side is exactly the same.
I will also need to look at what i will put at the bottom of the legs.
It will be one part cut three times to make this stool as each side is exactly the same.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment